2003 Chevy Silverado 1500 project I’ve owned and built this truck for the last 10 years 32k no motor or transmission Front of truck - Brand new mazulla race kit , never ran only tacked on . Brand new mazulla race hubs Brand new king coil overs (no bypasses but can run up to a 4.0 bypass which was the plan until planning to sell) Brand new king bump stops Brand new Izzy fab engine cage Brand new triton tube connectors for engine cage x Lewis built swing set steering Brand new gear box Hydroboost brake system Lewis built front rack n pinion delete crossmember (not on truck yet , so can still run rack n pinion ) Fiberwerx glass all included Stock core support Brand new grill Brand new headlights and light brackets Izzy fab 4l80e conversion crossmember I have a custom drive shaft to run the 4l60e but it’ll have to be shortened to run the 4l80e Cab- Te designs cab cage fully Tig welded Setup for two seats and a kids seat (can be swapped for a third adult seat with modifications) I have the two seats Brand new fiberglass dash Brand new pci race radio setup with kenwood upgrade Rear of truck - Te designs back half fully Tig welded Te designs 60” links Tig welded 55 gallon fuel safe fuel cell mounted against cab Fuel pump , pre filter and post filter all mounted under tank on frame rail I have an extra fuel pump also Setup to run two spares laying down with y straps(included) Sway away sway bar Has king coil overs with finned reservoirs Can fit up to 4.0 bypass , I sold the old bypasses to get upgrade to before planning to sell Battery mounted in the trunk with a breaker Camburg 3.5 housing with Currie unit bearing ends , 35 spline axles, strange third member spooled with 5:14 gears , wilwood brakes I have all the tubes to build out the trunk lid Wheels and tires- 6 race line wheels and tires on 39” Bfg projects I have 11 Bfg projects for it and two 37” Bfg Misc- I have race nets Race horn Race medical kit All new oil for the motor All new coolant All new trans fluid All new fluid for rear end 8 panel switch pro New momo steering wheel I have a ton of stuff for this truck . It is basically complete besides some mild fab work need to finish firing the 39” tires but cut enough to clear 40’s The truck also needs a Holley terminator wiring harness and dash . I cut factory wiring out and planed to go that route for simplicity Overall the truck does need some work but it is close and has a ton of brand new parts and already has parts on it to with stand big power and desert abuse . The truck will be a badass truck once finished and done right .
Select the type of report you are sending;
Please include any of the following information.
Thanks for letting us know about your concerns.
Complete this form and press the SEND button.
Your message has been sent to the owner.
This link has been copied to the clipboard.