Hey everyone, back at it again. Sold a ton of stuff on the last round, and things have been going since. I have until the end of August in my shop and still have a few things I'd like to see in good homes.
Have a built, running and driving big block suburban pre runner on 37 inch military tires, registers as a diesel and is CA smog exempt,brand new 400 HD trans, 2.5 fox bypasses, national springs, psc ram assist with hydro boost, full dom cage from engine to bumper with shock mounts tied in, Reid knuckles with custom hi steer on huge heims, swing away tire carrier and winch bumper, huge powder coated roof rack, sound system with sub and much more.
Have a bitchn 1450 ranger roller that's about 80% done, has custom beams, steering, links and full float rear end all chromoly, sandy cone 5*5.5 race hubs, sway bar, hanneman one PC clip, art Carr shifter, 3.8 super coupe motor plan was twin turbo, aod trans
Also have 1450/8 f150, dom cage from dash to rear bumper nicely tucked into the sheet metal, all tig welded 4130 3 link and custom 9 inch, fuel cell can ready for bladder, 351&c6, front has tlr bent beams and custom radius arms, I have a brand new set of glass works un touched fenders, bedsides, and hood, also have four brand new bilstein 60mm coilovers with reservoirs for this project, as well as a bronco ttb front ready to extend and install.
Lastly, I have a huge saylor Beale compressor. It ran my buddies whole cnc shop. At least 120 gallon, single or three phase. I want 2 grand for it, had an offer before but never came through.
You guys know what this stuff is worth, don't insult me with bs. All quality fab work no junk, not trading either I'm downsizing. Not parting out, if you just want parts then you part out. Text me anytime, and please don't be a tire kicker, I am busy but will send some more pics, but don't waste my time dreaming.