UTV 

320 HP Long Travel Z1 Swap 4-Seat RZR

14 Polaris RZR XP 4 1K$30,000.00
For Sale

the_owl, NM
 Aaron   Private Message
 (505)226-2276  
 related link

Selling my 14' Z1 Swapped 4 seat car. Tons of specs on the car, Ill put a few bullets and pics.

Full specs with some videos to the car can be found here http://utvforums.com/z1

All pics taken in May. Only used the car once since. Every wear part was replaced or upgraded at the time of swap.
Car has around 800 miles since swap in 2018. 48 hours ish
Z1 out of a 2012 Sled, with Turbine Tech Stage 2 Turbo. 49mm billet wheel. 2.25" intake. Its a big turbo. Cometic head gasket, arp studs.
3 stage tune. 250 280 320 with launch control. Big red knock light on the dash.
Toys for Big Boys cage
Wideband, Methanol injected and pump gas 24psi. Methanol tank is converted glove box and holds around twenty gas tank fillups worth of meth.
HCR Long travel, King Shocks Powdered to match paint.
Method 401, Terrabite 32"
Audi Nardo paint (Hecker and Spies). Shocker yellow powder
Twisted Stitch heated seats
All plumbed with nylon braided hose and AN fittings
Android Tablet has full engine info,gauges, logging and diagnostics in dash. Show all sensor info, boost, AFR, GPS speed, altitude etc.
300 watt Rockford motorcycle amp with 6.5 Rockfords all round. Wet sounds bluetooth and plays off in dash tablet. Add music by connecting to your wifi at home
Baja Designs Light bar, reverse and Squadrons
Lowrance 7m touch
Viper winch
Street legal with signals, horn, mirrors (AZ)
Air to Air intercooler between seats. Oil cooler under hood.
Quick Light whips green.
3 lithium Ion Batteries with bus bar connections.
Includes scattershield and custom clutch cover with two intake bilge fans and a huge 4" exhaust fan.
Includes 4 spare axles, 2 BNIB. 2 Summer Bros, 2 GSP.
Sandcraft carrier bearing gen 3, and Trans Bearing retainer plate.
Full glass Lock N Ride windshield modified to be removed in under 30 seconds. Very reliable.
Heretic studios Quick release steering
Rhys Millen wide fender flares
Then entire car can be taken apart. Not one wire isnt on a plug or harness. Full documentation with manuals, includes wire harness info, build manuals from Hawk Engineering, Polaris and Arctic Cat factory manuals.$40k in receipts (all parts, no paint powder or work) All special tools needed to work on car. That doesnt include cage, stereo or RZR itself. Also includes a new rebuilt Thunder 911 clutch weighted, shimmed and setup, ready to drop in at camp.

I have only blown one belt on this car and that was my first shake down trip to Sand Hollow. Also broke an axle and learned a lot.

Belt temps duning without a cover are in the LOW 200s.
I broke a motor mount drag racing for memorial day, ended up bending the output shaft of the tranny. Tranny is new rebuild with SKF bearings, and slight gear reduction. Great for running large tires with big HP.

Because of the motor mount break the wires to the oil temp sensor were ripped off. Im not fixing. Never should have put that sensor in anyway. With an oil cooler its fine all day.

No trades, title in hand. Im in ABQ but will meet in AZ with a deposit. $30k or $32k with a set of Skat Trak Xtreme 32x13x14 14 paddle Extreme and Buffs on OMF billet 3 piece wheels (yes the $650 ea ones). 2 trips on them. Wheels are 10in & 8in. Pics at the end. Beautiful wheels.

[email protected] is best contact.


    UTV   Listing #168830   Posted: Sep 14 Expires: Oct 29