Selling my Ford Bronco. Second photo is its current condition. Has a clean CA title with a new VIN on the driver door jamb from when I registered it in CA. I bought it in NM in 2017 and drove it to the beach and back until 2020 when I decided to tear it down for a full restoration. A lot of metal work has been done on it as it had a lot of rust in the usual places and I have gotten it to a point where it is nearly ready for blasting and paint. 302 and transmission ran fine before tear down. Odometer reads in the 40 thousands but may be broken. I will continue to work on it and will update the posting as things get finished. Here is a list of what's been done and what parts I have:

-New front floor installed
-New rockers installed
-New firewall installed
-New windshield cowel mount panel installed
-New A pillars installed
-New lower half of B pillars installed
-New wheel aprons installed
-New wheel wells installed
-New front fenders installed
-New shocks all around installed
-New body bushings installed
-New radiator core support uninstalled
-New battery tray uninstalled
-New front clip installation hardware
-Newish/not broken rear glass uninstalled
-Rear glass rubber
-Power window regulators
-Newish aluminum radiator
-New water pump
-Front grille has been blasted and powder coated primer
-Rivets holding the support bow on roof have been welded closed. I am working on welding the bow back on

Thing still need to be done:
-Patch two small holes in rear floor board
-Replace/patch the front grill
-The top looks to have quite a bit of filler on the driver side above the support bow
-Blast and Paint

Things I'll throw in if the deal is good: MSD ignition wires, new 31" BFG KO2s