Do to situation out of my control have decided to part ways with my dream build. The car is based off a class 1 center section that was fully tug welded and then build from that. I have over 60k in receipts just in parts let alone the time and cost of fab. The car was designed to run 40’s but can obviously handle anything smaller a lot easier. The car is 95% done on the fab side just need body, electrical, motor and trans. The trans already has. 6k deposit and is designed to run the 3 speed auto from transaxle engineering. Alls parts are included Full TT steering setup with 7” throw tt rack 50 gallon fuel cell for pre running Baja Full CBR cooking system - radiator - heat exchanger - trans cooler Seats Full ProAm hubs and 6 piston race calipers with 13” rotors hand picked for the car by Roy at ProAm Trans and motor are mock up’s but the deposit kn the trans is already put down for 6k 5 race line wheels King race series 3.5” bypass and coil overs Full size rear seat bar Floor boards done If you have any questions please feel free to contact me. Price is as follows 44k for entire car Or 28k for roller only includes hubs and trans deposit. No other parts
2019 Can Am Maverick x3x rc turbo rr
Ford Raptor PRO-2 Race Program 90K
2019 F250 XLT Lariat 4x4 36,000 Miles
2016 RACER ENGINEERING BEST HANDLING CLASS 10 FOR SALE
Street Legal 1968 Baja LS1 with Mendeola transmission.
2006 Jeep Wrangler Rubicon (the angry banana)
Select the type of report you are sending;
Please include any of the following information.
Thanks for letting us know about your concerns.
Complete this form and press the SEND button.
Your message has been sent to the owner.
This link has been copied to the clipboard.