2004 body style Chevy pre-runner
Fully built from by Miller Race Works
Front - Miller Race Works Long travel race kit up front with Fox 4.0 bypasses, Fox 2.5 coil overs, Fox 2.0 bumpstops with Miller Race Works slapper arms, suspension has 19.5” of travel.
Rear - Rear is back-halved, Miller Race works 4-linked, 27.5” travel, with Fox 4.0 bypasses and Fox 2.5 coil overs, Fox 2.0 bumpstops.
75 gallon Pyrotech fuel cell with Gieser Bros dry brake
2.5 Jamar hubs Front and rear with 14” rotors, Wilwood 6-piston calipers.
Motor - 6100 525 engine with ID Designs pre-runner plate, mil spec harness, an E67 ECU, set up just like a 6100 race truck.
Transmission Reed case 4L80, upgraded shafts, close ratio gear set
Tubeworks underdrive
3rd Member Gearworks 10” ring and pinion, full floater Rearend
Steering - Miller Race Works swing set steering with larger steering box and T pump
Large CBR radiator, 6 months old.
2 large CBR transmission coolers
C-Trab engine oil cooler
AIM PDM’s and dash, tons of sensors, shift position sensor with backup camera and GPS speedometer, Fiberwerks full size pre-runner dash, Kenwood 110w radio, PCI intercom, Vintage Air A/C and heater, dual Optima batteries
Sparco QRT seats
Lights - 6 GG lights in the grill, rear roof light on actuator with 9 GG pods, rear GG tail light bar
10lb SafeCraft fire suppression system
Brown and Miller Plumbing, Mil spec wiring
Trailer Products front and rear fiberglass
6 Pro-Am wheels with BFG 40’s
Storage compartment in rear for tools or misc
Snap-On jack
Full stainless custom exhaust and headers
Engine and transmission 800 miles since new
Currently registered in Arizona