Jimco Class 1 “Hammerhead” Model
No expense spared during initial build.
Lots of time, money, and R&D spent post build.
CAR IS FULLY PREPPED, 150 TEST MILES ONLY, ENGINE, TRANS AND SHOCKS FRESH. ALL NEW RPI HEIMS AND ROD ENDS AND UNI BALLS NEW.

Baja Designs Complete light package & rear tail light bar ((5) LP6 lights on bumper, (1) Roof light bar, (1) rear tail light bar)
Jimco Trophy Truck front end (bulkhead, control arms, spindles, tie rods, steering box system)
Power Steering Solutions Steering Components
72gallon Pyrotect Fuel Cell with Hydromat and Red Head
ID Designs front and rear hubs
Fox shocks (Coil Over and Bypass on each corner), front and rear bump stops
Carbon Fiber Dash
Motec displays (C125 on driver side, C127 on passenger side)
Motec Button Keypads (15 button and 8 button pads on driver side, (1) 15 button pad on passenger side)
Motec control dial on center console
Tire Pressure Monitor Sensors
Lowrance touchscreen gps (7” on driver side and 9” passenger side)
Turning Brake
All wiring done by TRH and James Lin
Kenwood radio
Intercomm with Bluetooth
Starlink Satellite Internet (subscription change required)
Icom Satellite Communication (subscription change required)
Impact Carbon Fiber HS1 Seats
Impact 2” Camlock Restraints with QSR
Mastercraft Custom elbow pad on center console
Mastercraft Custom Window Nets
C&R Custom Radiator and Coolers with heat exchanger
All Brown & Miller and XRP plumbing
Dual spare tire carrier
Brunnhoelzl pump jack
40” BFG KR3’s on Method machined finished wheels
Fiberglass Body
All Aluminum paneling
Dougans Racing Engines Chevy Small Block Spread Bore with Electronic Throttle Pedal
Richer Auto Electric Alternator
8-1 custom headers and exhaust
Fortin FRS5 4.0 Sequential Transmission with Dual Air Compressors and Paddle Shifters
Dual Tilton Starters